11
on: December 31, 2014, 10:13:21 pm
|
Started by GRUBDIGGER - Last post by conductor_81
|
Freshen it up and run it hard then my friend!!
|
12
on: December 31, 2014, 10:11:32 pm
|
Started by conductor_81 - Last post by conductor_81
|
From what I can tell grubby is the bolt patterns are the same but the ports in the 49 heads are bigger. He got engine very hot some how and it warped the heads the block is ok but heads are not on the block. If I can make 44 heads work I would find a set of those.
|
13
on: December 31, 2014, 11:42:19 am
|
Started by conductor_81 - Last post by GRUBDIGGER
|
ARENT THE HEADS THE SAME AS A 44?
|
14
on: December 31, 2014, 11:39:49 am
|
Started by GRUBDIGGER - Last post by GRUBDIGGER
|
IM USEING AARONS OLD SUPER SPORTSMAN ENGINE. I HAVE A KAW ON THE BACK BURNER.
|
15
on: December 31, 2014, 11:36:18 am
|
Started by trbinrat - Last post by GRUBDIGGER
|
SOUNDS LIKE YOU NEED 10 POUNDS OF WIEGHT OVER THE FRONT AXLE. ALL THAT POWER WONT KNOW ITS THERE.
|
16
on: December 22, 2014, 02:58:41 pm
|
Started by conductor_81 - Last post by conductor_81
|
Ok update I may have founds rods not a set deal yet but am in need of heads yet. But will keep options open for rods also. Thanks again.
|
17
on: December 21, 2014, 09:39:08 pm
|
Started by GRUBDIGGER - Last post by conductor_81
|
Mark I second that motion
|
18
on: December 21, 2014, 09:14:10 pm
|
Started by conductor_81 - Last post by conductor_81
|
Thank you for trying mark. Like I said I'm trying to help a guy out so if anyone has some or comes across any thing I would appreciate it. Rods and heads are needed. Again thank you mark and merry Christmas to everyone.
|
19
on: December 21, 2014, 04:18:39 pm
|
Started by conductor_81 - Last post by trbinrat
|
I just check with him and they are all gone. Sorry.
I would try ebay.
|
20
on: December 21, 2014, 12:04:43 pm
|
Started by trbinrat - Last post by trbinrat
|
Well It's been a while since I posted on this one. I finally got it all together and raced it once. I couldn't keep the front wheels on the ground so I need to do some modifications to the chassis to get it to work.
So for now the motor went into my other chassis. Hopefully I'll get it straightened out.
|
|